6ES7148-4PC00-0HA0 SIMATIC ET200PRO PS 24 V/8 A, IP67

6ES7148-4PC00-0HA0 SIMATIC ET200PRO PS 24 V/8 A, IP67

Product Code: 6ES7148-4PC00-0HA0

Availability: In Stock

Price: $197.97
Qty:
Add to Wish List
Add to Compare
  
 
SIMATIC ET200pro PS, 24 V, 8 A
SIMATIC ET200PRO PS STABILIZED POWER SUPPLY DEGREE OF PROTECTION IP67 INPUT: 400-480 V 3 AC OUTPUT: 24 V DC / 8 A
Technical specifications
Product SIMATIC ET200pro PS
Power supply, type 24 V/8 A
Input
Input 3-phase AC
Supply voltage / with AC / minimum rated value 400 V
Supply voltage / with AC / maximum rated value 480 V
Supply voltage  
  • with AC
 340…550 V
  • Note
 320 ... 340 V for max. 1 min
Wide-range input Yes
Overvoltage resistance Implemented internally with varistors
Mains buffering at Iout rated, min. 15 ms
Mains buffering at Vin = 400 V
Rated line frequency 50/60 Hz
Rated line range 45...66 Hz
Input current / at rated input voltage 400 V 0.5 A
Switch-on current limiting (+25 °C), max. 40 A
I²t, max. 3.5 A²·s
Built-in incoming fuse T 4 A
Protection in the mains power input (IEC 898) Required: Circuit breaker 3RV2011-1DA10 or 3RV2711-1DD10 (UL 489)
Output
Output Controlled, isolated DC voltage
Rated voltage Vout DC 24 V
Total tolerance, static ± 3 %
Static mains compensation, approx. 0.5 %
Static load balancing, approx. 0.5 %
Residual ripple peak-peak, max. 200 mV
Spikes peak-peak, max. (bandwidth: 20 MHz) 250 mV
Product function / Output voltage adjustable No
Output voltage setting -
Status display Green LED for 24 V OK
Signaling max. 30 V, 10 mA; Power-Good (High-Pegel 1L+ for Vout in range 21.3 ... 29 V); Overtemperature warning at least 30 s before switch-off (high level 1L+ when the max. internal temperature is exceeded)
On/off behavior Overshoot of Vout < 2 %
Startup delay, max. 1.5 s
Voltage rise, typ. 40 ms
Rated current value Iout rated 8 A
Current range 0…8 A
Active power supplied / typical 192 W
Short-term overload current / on short-circuiting during the start-up / typical 50 A
Duration of overloading capability for excess current / on short-circuiting during the start-up 100 ms
Short-term overload current / at short-circuit during operation / typical 50 A
Duration of overloading capability for excess current / at short-circuit during operation 100 ms
Parallel switching for enhanced performance No
Efficiency
Efficiency at Vout rated, Iout rated, approx. 88 %
Power loss at Vout rated, Iout rated, approx. 25 W
Closed-loop control
Dynamic mains compensation (Vin rated ±15 %), max. 0.5 %
Dynamic load smoothing (Iout: 50/100/50 %), Uout ± typ. 1 %
Setting time / maximum 2 ms
Protection and monitoring
Output overvoltage protection < 33 V
Current limitation, typ. 9.4 A
Property of the output / Short-circuit proof Yes
Short-circuit protection Electronic shutdown, automatic restart
Enduring short circuit current / RMS value / maximum 10 A
Overload/short-circuit indicator -
Safety
Primary/secondary isolation Yes
Galvanic isolation Protective extra low output voltage Vout according to EN 60950-1 and EN 50178
Protection class Class I
Leakage current / maximum 3.5 mA
Leakage current / typical 0.4 mA
CE mark Yes
UL/CSA approval Yes
UL/cUL (CSA) approval UL-Listed (UL 508)
Explosion protection -
FM approval -
CB approval Yes
Marine approval -
Degree of protection (EN 60529) IP67, enclosure type 4 indoor
EMC
Emitted interference EN 55022 Class A
Supply harmonics limitation -
Noise immunity EN 61000-6-2
Operating data
Ambient temperature / during operation -25…+55 °C
  • Note
 with natural convection
Ambient temperature / during transport -40…+70 °C
Ambient temperature / during storage -40…+70 °C
Humidity class according to EN 60721 Climate class 3K3, no condensation
Mechanics
Connection technology screw-type terminals
Connections / Supply input L1, L2, L3, PE: Plug connector HAN Q4/2 (counterpart see "Electrical accessories")
Connections / Output L+, M: 2 x 1.5 mm² each (4-pole cable for +/- with open, labeled ends, 4 x 1.5 mm²)
Connections / Auxiliary Alarm signals: M12 plug-in connector 5-pin
Width / of the enclosure 310 mm
Height / of the enclosure 135 mm
Depth / of the enclosure 90 mm
Weight, approx. 2.8 kg
Product property / of the enclosure / housing for side-by-side mounting No
Mounting type / wall mounting Yes
Mounting type / Standard rail mounting No
Mounting type / S7 rail mounting No
Installation Can be mounted onto ET200pro mounting rail
Electrical accessories Power connector (Input: 3RK1911-2BE30 (6 mm²)) (Output: 3RK1911-2BF10 (4 mm²))
Other information Specifications at rated input voltage and ambient temperature +25 °C (unless otherwise specified)
   
 
letzte Änderung:
Oct 10, 2014

Write a review

Note: HTML is not translated!

Rating: Bad Good

Enter the code in the box below:

Continue
Fatal Error: Can't alloc dataspace in /www/wwwroot/www.kollewin.com/system/secache/secache.php on line 617 Warning: fopen(/www/wwwroot/www.kollewin.com/system/logs/error.txt): failed to open stream: Permission denied in /www/wwwroot/www.kollewin.com/system/library/log.php on line 12 Warning: fwrite() expects parameter 1 to be resource, boolean given in /www/wwwroot/www.kollewin.com/system/library/log.php on line 14 Warning: fclose() expects parameter 1 to be resource, boolean given in /www/wwwroot/www.kollewin.com/system/library/log.php on line 16 Warning: alloc datasize:976632435 in /www/wwwroot/www.kollewin.com/system/secache/secache.php on line 617 Warning: fopen(/www/wwwroot/www.kollewin.com/system/logs/error.txt): failed to open stream: Permission denied in /www/wwwroot/www.kollewin.com/system/library/log.php on line 12 Warning: fwrite() expects parameter 1 to be resource, boolean given in /www/wwwroot/www.kollewin.com/system/library/log.php on line 14 Warning: fclose() expects parameter 1 to be resource, boolean given in /www/wwwroot/www.kollewin.com/system/library/log.php on line 16